Casio PRW-6600YB-3ER bruksanvisning

Casio PRW-6600YB-3ER
8.6 · 2
PDF bruksanvisning
 · 16 sider
bruksanvisningCasio PRW-6600YB-3ER
2. Check the Home City and the daylight saving time (DST) setting.
Use the procedure under “To confi gure Home City and summer time settings” (page E-34) to confi gure your
Home City and daylight saving time settings.
Proper time calibration signal reception, and World Time Mode data depend on correct Home City,
time, and date settings in the Timekeeping Mode. Make sure you confi
gure these settings correctly.
3. Set the current time.
To set the time using a time calibration signal
See “To get ready for a receive operation” (page E-21).
To set the time manually
See “Confi guring Current Time and Date Settings Manually” (page E-36).
The watch is now ready for use.
For details about the watch’s radio controlled timekeeping feature, see “Radio Controlled Atomic
Timekeeping” (page E-19).

Things to check before using the watch

1. Check the battery power level.
Hold down
for at least two seconds to enter the Timekeeping Mode and display the battery power
The battery power level will be indicated as
on the left
side of the digital display.
Battery power
Does any one of the following conditions exist?
ashing on the digital display.
” is fl ashing on the display.
The watch is charged
suffi ciently.
For details about
charging, see
“Charging the Watch”
(page E-12).
Power is low.
Charge the watch by placing it in a location
where it is exposed to light. For details, see “Charging the
Watch” (page E-12).
Go to step 2.
is fl ashing, the second hand will jump at two-second intervals.
is fl
ashing, all hands will move to and stop at 12 o’clock.
If you do not perform any operation for more than two minutes after pulling out the crown, the indicator
shown below will appear and crown operations will become disabled. If this happens, push the crown
back in and then pull it out again to re-enable crown operations.
Pulling out the crown while the watch is in a mode that does not allow confi guration of any settings will
cause the indicator shown below to appear. If this happens, push the crown back in and lock it.
The indicator shown below also appears when performing hand home position adjustment. See “Hand
Home Position Adjustment” (page E-39) for more information.
1 second
You can use high-speed movement in the following cases: when changing the time and/or date setting
in the Timekeeping Mode, World Time Mode, Countdown Timer Mode, or Alarm Mode, or when
performing magnetic declination angle calibration, altitude calibration, barometric pressure calibration,
or temperature calibration operations.

High-speed Movement

You can use either of the crown operations described below to move watch hands or indicators at high
HS1: Can be used to move both hands and display indicators.
HS2: Can be used when setting the hour and minute manually to move the hands at high speed.

To start HS1 high-speed movement

While the crown is pulled out, rotate it rapidly away from you (forward) or
towards you (reverse) until the desired HS1 high-speed movement starts.

To start HS2 high-speed movement

While HS1 high-speed movement is in progress, again rotate the crown rapidly,
away from you (forward) or towards you (reverse) in the same direction as the
HS1 movement until HS2 high-speed movement starts.

To stop high-speed movement

Rotate the crown in the direction that is opposite that of the current high-speed
movement or press any button.

Using the Crown

The crown of this watch is a screw in lock crown. Before using the crown,
you must fi rst rotate it towards you to loosen it. After performing crown
operations, be sure to press the crown in lightly as you screw it back in.
To maintain water resistance and avoid impact damage to the crown,
be sure to screw it back in when you are not using it.
The illustrations below show the different crown operations.
Pull out Rotate Push in

About This Manual

Depending on the model of your watch, digital display text appears
either as dark fi gures on a light background, or light fi gures on a dark
background. All examples in this manual are shown using dark fi gures
on a light background.
Button operations are indicated using the letters shown in the
Note that the product illustrations in this manual are intended for
reference only, and so the actual product may appear somewhat
different than depicted by an illustration.
Second Hand
CrownMode Hand
Hour Hand Minute Hand


Important Altimeter and Compass Information!
The watch’s Altimeter Mode calculates and displays relative altitude based on barometric pressure
readings produced by its pressure sensor. This means that readings taken at different times at the
same location may produce different altitude values due to changes in barometric pressure. Also note
that the value displayed by the watch may be different from the actual elevation and/or sea level
elevation indicated for the area where you are located.
When using the watch’s altimeter while mountain climbing, be sure to perform regular calibration in
accordance with the local altitude (elevation) indications. For more information, see “To specify a
reference altitude value” (page E-56).
Whenever you use the digital compass of this watch for serious trekking, mountain climbing, or other
activities, be sure always to take along another compass to confi
rm readings. If the readings produced
by the digital compass of this watch are different from those of the other compass, perform bidirectional
calibration of the digital compass to ensure more accurate readings.
Direction readings and digital compass calibration will not be possible if the watch is in the vicinity of a
permanent magnet (magnetic accessory, etc.), metal objects, high-voltage wires, aerial wires, or
electrical household appliances (TV, computer, cellphone, etc.)
Congratulations upon your selection of this CASIO watch.
To ensure that this watch provides you with the years of service for which it is designed, carefully read
and follow the instructions in this manual, especially the information under “Operating Precautions” and
“User Maintenance”.
Keep all user documentation handy for future reference.


The built-in sensors of this watch measure direction, barometric pressure, temperature and altitude.
Measured values are then shown on the display. Such features make this watch useful when hiking,
mountain climbing, or when engaging in other such outdoor activities.
Warning !
The measurement functions built into this watch are not intended for taking measurements that
require professional or industrial precision. Values produced by this watch should be considered
as reasonable representations only.
When engaging in mountain climbing or other activities in which losing your way can create a
dangerous or life-threatening situation, always use a second compass to confi rm direction readings.
Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any damage or loss
suffered by you or any third party arising through the use of your watch or its malfunction.


Operation Guide 5571

Se håndboken for Casio PRW-6600YB-3ER her gratis. Denne håndboken er under kategorien Armbåndsur og har blitt vurdert av 2 personer med et gjennomsnitt på 8.6. Denne håndboken er tilgjengelig på følgende språk: Engelsk. Har du et spørsmål om Casio PRW-6600YB-3ER eller trenger du hjelp? Still spørsmålet ditt her

Trenger du hjelp?

Har du spørsmål om Casio og svaret står ikke i manualen? Still spørsmålet ditt her. Gi en klar og omfattende beskrivelse av problemet og spørsmålet ditt. Jo bedre problemet og spørsmålet beskrives, jo enklere vil det være for andre eiere av Casio å kunne gi deg et godt svar.

Rune United Greaker • 29-10-2021Ingen kommentarer

hvordan stiller man datoen på Protrek 6600YB

Svar på dette spørsmålet

Antall spørsmål: 1

PRW-6600YB-3ER | PRW-6600YB-3ER
Brukermanual (PDF)
Hovedfarge på reimGrønn
Klokkeetuiets materialeHarpiks
Armbånd, materialeHarpiks
Hovefarge på urskiveGrå
Tekniske detaljer
Elektronisk kompassJa
Opplyste tasterJa
Ur-innstilling12 timers/24 timers
Nøyaktighet-15 - 15 sek/måned
Vannbestandig trykknivå10 ATM
Nedtellingsområde1 - 60 min
Stoppeklokkens målekapasitet24 h
Stoppeklokkens presisjon0.01 s
MekanismetypeQuartz (solar)
UrskivetypeAnalog og LCD-urskive
Vekt og dimensjoner
Bredde51.5 mm
Dybde13.6 mm
Høyde51.6 mm
Vekt80 g
vis mer

Finner du ikke svaret på spørsmålet ditt i manualen? Du kan finne svaret på spørsmålet ditt i Vanlige spørsmål om Casio PRW-6600YB-3ER under.

Finner du ikke spørsmålet ditt i listen? Still spørsmålet ditt her

Ingen resultater