Lenmar SOLOXP-X17 bruksanvisning

Har kan du se manualen Lenmar SOLOXP-X17 gratis. Har du lest manualen men det ga deg ikke svar på spørsmålet ditt? Da kan du stille spørsmålet til andre eiere av Lenmar SOLOXP-X17 på denne siden.

SoloXP
Series Li-Ion Battery charger for
Digital cameras and Video Camcorders
PLEASE READ THE INFORMATION AND FOLLOW ALL INSTRUCTIONS THOROUGHLY
BEFORE USING THIS PRODUCT.
Introduction
Thank you for purchasing the SoloXP travel charger. The SoloXP charger with the
appropriate adapter plate is a fully automatic battery charger which is compatible with
virtually all 3.6 8.4 Volt Lithium-Ion batteries for camcorders and digital cameras
from Sony, Canon, JVC, Panasonic, Nikon, Kodak, FujiFilm, Sharp, RCA and other
manufacturers. This charger uses a variety of adapter plates to make it compatible with
existing batteries as well as batteries that will be developed into the future. Visit
www.lenmar.com/SoloXP for up to date adapter plate compatibility list.
The SoloXP charger uses digital microprocessor technology to provide a safe, full
charge every time. Charging status is provided by the built-in 2-color LED indicator.
In addition, the SoloXP has an integrated USB Port so it can also provide the power to
recharge your PDA, cell phone, MP3 player, handheld game, or any other device that
can be charged from a USB port (compatible cables not included).
Charging
Attach the adapter plate for the specific battery you will be charging.
Removing the Adapter Plate
To change the adapter plate you want attached, you will need to remove the adapter
plate first by pushing down on the plate and applying firm pressure to slide it away to
the right of the charger base. Then, attach the selected adapter plate to the charger
unit by placing the adapter plate onto the charger, aligning the pointer on the adapter
plate to the pointer on the charger base. While pressing down on the adapter plate,
slide the plate firmly to the left on the charger base until it stops.
See diagram below.
USB Power
The USB charging port on this unit may be used with any USB compatible device that
is used with “Charge” or “Charge / Sync” USB cables and will provide power via that
cable to the device allowing it to charge itself. The USB port is available for use at any
time while the SoloXP charger is plugged into an AC outlet. While the SoloXP charger
is plugged into AC power, simply connect your USB cable to your device and then
plug into the USB port on the side of the SoloXP. At this time the device will indicate
that it is receiving power and charging its internal battery.
You may simultaneously charge your digital camera or camcorder while
powering/charging another device thru the USB. This will not effect the battery
charge time.
Trouble Shooting Tips
• If the LED status indicator does not light up when the charger is plugged into AC
power, check to make sure that the AC outlet has power.
• If the battery is attached, and the status indicator does not show charging, the
battery contacts may not be properly connecting to the adapter plate. Unplug the
unit and check connection of the battery to the adapter plate. Also, make sure
the adapter plate is the proper one and that it is securely attached to the charger.
• Use a clean dry cloth when necessary to keep the metal contacts of both charger
and battery clean.
Specifications
Input 100-240VAC, 50-60Hz
Output Charger - 4.2 / 8.4VDC, 400mA max.
USB – 5.25VDC, 200mA max.
Compatibility: 3.6 – 8.4 Volt Lithium-Ion (Li-Ion) rechargeable batteries
Charge Indicator: Green – Charge complete or no battery installed
Red - Charging
Cautions
• For use with 3.6 – 8.4V Lithium-Ion (Li-Ion) batteries ONLY! Use with other type
batteries voids warranty, may cause damage to the charger/ battery and possibly
cause injury to the user.
• Do not leave a battery connected to the charger when it is not plugged into AC
power.
• For best battery life, we suggest recharging Li-Ion batteries after use and before
being put away.
• Do not leave the battery connected to the charger for prolonged periods. Remove
the battery after charge is complete.
• Unplug the charger from AC power when not in use.
• Indoor use only. Do not use, place or store the charger where it may come into
contact with water or moisture.
• No user serviceable parts, opening chassis will void warranty.
The indicator LED will also be Green if the SoloXP is plugged into AC power without a
battery installed. Once the charge is complete, we recommend that you unplug the
charger from AC power and remove the battery from the charger.
Install the battery to be charged onto the adapter plate. Flip down the AC plug on the
rear of the charger and plug into AC outlet. The LED charge indicator on the top of the
unit will turn Red to indicate that the battery is being charged. Once the charge is
complete, the indicator LED will turn Green.
Approximate charge times are shown below.
Limited 3 Year Warranty
This limited warranty starts from the date of original purchase and expires three years
thereafter. If, during this period, any part, because of manufacturing defects or
workmanship, fails to function properly under normal use it will be repaired at no
charge for parts and labor or, at our option, the product will be replaced. The
following is excluded: damages from delay or loss of use of equipment or damaged
batteries, malfunctions resulting from misuse, tampering, unauthorized repairs,
modifications or accident.
Package the unit and its accessories carefully using ample padding material to prevent
damage in transit and ship it prepaid and insured to:
LENMAR ENTERPRISES, INC.
4035 Via Pescador
Camarillo, CA 93012 USA
When sending in product for service, your package should include evidence of date
and place of purchase. Enclose $10.00 for shipping and handling for addresses in the
U.S. and $15.00 in Canada. For outside the U.S. and Canada, freight will vary
depending upon ship-to address.
For additional questions, comments or to explore other Lenmar battery solutions, visit our
web site at: www.lenmar.com or call 805/384-9600 from 9AM – 5PM PST.
307-030-CT
Batt. Volt./Capacity
3.6V, 650mAh
3.6V, 1200mAh
7.2V, 650mAh
7.2V, 1200mAh
7.2V, 2400mAh
Max Charge Time*
2 hrs.
4 hrs.
2 hrs.
4 hrs.
8 hrs.
* - All times are approximate and will vary depending on battery condition and level of discharge.

Har du et spørsmål om Lenmar SOLOXP-X17?

Still spørsmålet som du har om Lenmar SOLOXP-X17 til andre produkteiere her. Gi en klar og dekkende beskrivelse av problemet og ditt spørsmål. Jo bedre problemet og spørsmålet beskrives, jo enklere vil det være for andre eiere av Lenmar SOLOXP-X17 å kunne gi deg et godt svar.

Spesifikasjoner

Merke Lenmar
Modell SOLOXP-X17
Produkt Batterilader
EAN []
Språk Engelsk
Produktgruppe Batteriladere
Fyltype PDF
Energihåndtering
Driftsspenning 4.2V
Output-strøm 0.4A
Innput-frekvens 50/60Hz
Andre funksjoner
Kjemisk sammensetning Lithium Ion
Oppladingstid 240min
Kompatibilitet Ca✗n BP-208, Canon BP-308, Canon BP-315, Konica Minolta / Rollei / Vivitar 02491-0026-00
Design
Produktfarge Sølv
Tekniske detaljer
Vekt (britisk) 0.61Ibs
Pakkevekt (imperial) 0.86Ibs