Saris Cycle-On Pro bruksanvisning

Har kan du se manualen Saris Cycle-On Pro gratis. Har du lest manualen men det ga deg ikke svar på spørsmålet ditt? Da kan du stille spørsmålet til andre eiere av Saris Cycle-On Pro på denne siden.

20" wheel
tray mount
Standard wheel
tray mount
USER MANUAL
CCyyccllee--OOnn PPrroo
Please READ and FOLLOW all instructions carefully.
4017 (1 1/4” RECEIVER) OR 4018 (2” RECEIVER)
ASSEMBLE FRONT WHEEL TRAYS - Determine which holes you
will use to mount the front wheel trays (Fig. 1A). For 20” tires inner-
most holes must be used(20” tire bikes cannot be mounted on the
#4012 add on kit).
Tube
Bolt
Front Wheel
Tray
Washer
Nut
Insert bolt through tube, slide wheel tray on, fasten with washer
and nut (Fig. 1B). Tighten nut until it is snug, where wheel tray
pivots freely. Repeat for each of the 2 front wheel trays.
Next attach the rack to the tilt bracket. Assemble in stepped
order (step 1, 2, 3) as shown above. Tighten knob at end of
bracket until bracket is tight in receiver.
1
2
3
Insert plugs into
unused holes.
1A
1B
2B
MUST use 2 wheel trays per wheel.
See Picture 4B.
Front Wheel
Tray
Washer
Nut
Bolt
Tube
Insert hitch pin and lock into place as shown above. (Note:
Do not stick locking cable through hole, only hitch pin.)
Steel Pin
Pin with
Lanyard
Knob
1
2

Har du et spørsmål om Saris Cycle-On Pro?

Still spørsmålet som du har om Saris Cycle-On Pro til andre produkteiere her. Gi en klar og dekkende beskrivelse av problemet og ditt spørsmål. Jo bedre problemet og spørsmålet beskrives, jo enklere vil det være for andre eiere av Saris Cycle-On Pro å kunne gi deg et godt svar.